How to open the magnetic valve switch? How to open the magnetic gate valve without a key

How to open the magnetic valve switch? How to open the magnetic gate valve without a key

Magnetic valve is widely used, can better maintain the safety of property, magnetic valve for the convenience of use, safety, by many community owners love, but in the process of opening the magnetic valve often occur some small problems, so how to open the magnetic valve switch? How to open magnetic gate valve without key? Today, like Valve explains how to enable the magnetic valve for you!

How to open the magnetic valve switch
The whole process is used when the valve body is opened, adjusted, closed and the locking cap is opened.
Set the key on the lock cap, so that the red point on the key points to lock a small point, gently down two times, the lock cap that spring up, that is, in the open situation, up the lock cap can be dragged.
Two, magnetic gate valve without a key how to open
1. If you don’t have a key, you need to prepare special tools, lots of magnets and auscultation in advance.
2, everyone carries auscultation, put one end on the magnetic valve, the other hand holding the magnet, moving back and forth on the magnetic valve.
3, after looking for magnetic points, be sure to do a good job of identification.
4, the magnetic valve mark at the magnet suction, and then can be opened.
Three, magnetic valve application common problems
1, in the process of installing magnetic valve, must be very careful, can not be installed by brute force, especially in the magnetic valve switch. If the impact of the magnetic valve switch is too large, it is very easy to cause damage, harm the future application.
2, if the surrounding electromagnetic field is very strong, it is better not to use the magnetic valve, or the magnetic will harm the magnetic switch, not up to the actual effect. And in the installation of the use, can not be combined with the transmission line driving line.
3, in the application of magnetic switch process, do not put it into the water refrigerant, otherwise it will harm the conventional application of the switch. If must be applied below this condition, be sure to cover with outside cover.
4, in the magnetic valve installation process, the switch and load should be connected together, and then access to the switching power supply, to ensure normal application. In addition, the working voltage and current of the load shall not exceed the allowable scope of the magnetic switch.